19
Front panel display
© 2016 ITEL Elettronica e Telecominicazioni Snc
2.3.3
Audio processor preset selection
If
function was enabled, it will be possible to choose a different preset for each
audio source, which can be selected in the previous menu, otherwise this window will not be visible.
Once selected a preset, it can then be edit into the Audio Processor section.
The loaded preset will be assigned to the audio source currently on air.
2.3.4
Audio fallback setup (audio backup)
The processor can be set to automatically switch to an auxiliary input source if the main input audio
level is below a minimum threshold.
Fallback (ON/OFF):
Enable / Disable automatic audio fallback on backup source.
OnAir:
audio source actually on air
I1 - I2 - I3:
Channel list. The channel are listed by order of priority, with maximum priority assigned
to channel 1.
When an high priority channel will become unavailable, it will be replaced by a lower priority one until
its recovery.
AlmTime:
Alarm timeout
Back Time:
Back timeout. It is the time for which the main audio source must be above the
minimum threshold before it can be set back on air.
AlmThr:
minimum audio level threshold
The main audio source is considered valid If the level of both channels L / R are above the alarm
threshold. If a single channel is less than the alarm threshold for a period longer than the alarm
timeout, the backup source will be put on air.
When the main audio source will recover, once elapsed the "Back Timeout", it will be put back on
air.
Changes will be applied upon exiting the menu.
Summary of Contents for DPRO3
Page 4: ...Section 1 Description ...
Page 9: ...Section 2 Front panel display ...
Page 25: ...Section 3 Programmming software ...
Page 43: ...Section 4 RD Link ...
