- 7 -
PRODUCT’S GENERAL CHARACTERISTICS
Thanks for having purchased a motorized projection screen. Enjoy the show!
The screens produced and distributed are built in compliance with the dispositions of the follow-
ing E.E.C. directives: low voltage E.E.C. directive 73-23, electro-magnetic compatibility E.E.C.
directive 89-336.
All employed projection fabrics are fire-proof certified. The fire-proof degree and relative classifi-
cation class vary according to the type of projection fabric used.
The frame is realized in aluminium with powder anti-scratch paint, of white colour (standard
version).
WARNINGS AND PRECAUTIONS
Make sure that no part of the screen has been damaged during transport. Eventual damages
caused during transport must be immediately signalled to the carrier and anyhow, within 8 days
from receiving the product, penalty the waiving of the warranty. Prior to removing the eventual
package, make sure that the product is laid on a flat surface, suitable to support it. Remove the
package by opening it from the closing edges. Check that all accessories described herein under
are present.
STANDARD ACCESSORIES
2 brackets for ceiling and/or wall assembly
1-10 A, 250 V a.c. unipolar commutator, with directional arrows and central OFF position com-
plete with cummutator-holder container for exterior installation to cantilever wall
1 instructions manual
1-4 mm hexagon headed key to adjust end stops
The standard electrical cables are contained in a single case of self-extinguishing plastic mate-
rial; nonetheless, wall or ceiling anchoring must comply with norm 46/90 and must be performed
by suitable staff. In case of failure of one of the two end stop’s adjusting screw, located on the
electrical motor, a thermal device is envisaged, which is able to intervene and open the electrical
circuit. The assembly was studied to obtain maximum safety.
ADOPTED SAFETY CRITERIA
SCREEN UNPACKING
ENG
ENGLISH
