Installation at the CENTRE of the room:
Install the appliance so as not to block the
screens (1 and 2), used to make future main-
tenance/repair easier.
- take the appliance out of the packaging, being care-
ful not to damage the panels (3);
- lift the appliance, stopping it with the side support
foot (4, supplied), to make all subsequent installation
operations easier;
- remove the side screens (5) by loosening the
screws (6);
- position the appliance after deciding the pipe layout
(Extraction, Exhaust and Gas supply):
TYPE A) Extraction, Exhaust and Gas from
above;
TYPE B) Extraction in environment, Exhaust and
Gas supply from below under the floor;
In view of the various types of installation offered by the
appliance, the Manufactures simply provides basic instruc-
tions regarding safety and fitting, so as not to restrict the end-
less options used or conceived by the installer.
Make sure the chosen or conceived parts, for
fastening the appliance, are suitable for suppor-
ting the weight of the appliance taking into account
above all the material from which the wall is made.
- fasten the appliance in the desired position;
Use the anchors most suitable for suppor-
ting the weight of the appliance and for the
material from which the wall on which the
appliance is being fastened is made.
TYPE A)
Use the fastening KIT (5) or fit adequate
brackets both to the ceiling (see bracket 11) and to
the floor (see bracket 13), able to secure the applian-
ce firmly and sturdily;
TYPE B)
Use the fastening KIT (5) or fit adequate
brackets to any false ceiling (see bracket 11) and
floor (see bracket 13), able to secure the appliance
firmly and sturdily;
- mark the centre point on the wall and then make
the holes for the extraction and exhaust pipes
(SPLIT or SINGLE end piece);
- make a Ø 110 mm hole in the wall (1 SPLIT end
piece) or a Ø 54 mm hole (2 SINGLE end pieces);
ALWAYS insulate the exhaust pipe to pre-
vent malfunctions due to the formation of
condensation;
- connect the pipes to the appliance;
- now bring the front and rear panels (3) up to the
appliance;
- fit the screen (1 or 2) back on.
16
INSTALLER
3
1
2
type
B
type
A
5
6
11
6
8
7
10
9
12
h
5
6
9
11
13
13
Summary of Contents for faro
Page 1: ......
Page 40: ...3520300031 Rev 2...
