INSTALLATION MANUAL · iSmartGate 01W ·
English / REV.3
9
iSmartGate-01W
www.
v2fe
.com
2.2.2 iSmartGate PULSE Mode Wiring
As iSmartgate-01W has two free potential outputs, it allows to control opening and close of the following elements:
· Awnings · Blinds ·Curtains
In case the AC current of the motor we need to control is equal or below the data shown on
figure 6
,
you need to install the
iSmartgate-01W
as follows:
In order to do so, it is important to take into account
which is the maximum ELECTRIC CURRENT at witch
work the electric motor you want to control, which
should never surpass the values shown on
figure 6.
In most cases, the existing control devices for those
elements already come with a relay incorporated on
it, so that we will not have to worry about the maxi-
mum elecrtic current.
In case the electric motor of the device we want to
control has higher DC current, you will need to add
an INDUSTRIAL CONTACTOR between the
iSmartGate-01W
and the electric motor.
Figure 6. DC Current / DC Voltage for each
of the RELAY outputs
Figure 7. Wiring to control
awnings, blinds, etc.
L
N
iSmartGate-01W
M1
The electric element connected to
the iSmartgate Device needs to
have its own limit switch
in
order to stop the action on a safe
way at any time, one at the upper
limit and other in the lower
end of the process.
ATTENTION
LED STATUS
LED OUTPUT 1
LED OUTPUT 2
P.E N L
110/220AC
SEL BACK OK
RELAY 1
RELAY 2
Wi-Fi
