iSmarGate 01W, Instructions For Use Manual

Page: 7 / 29

INSTALLATION MANUAL · iSmartGate 01W · English / REV.3
7
iSmartGate-01W
www. v2fe .com
2.2 Wiring Load
Installation and Disconnection must be done without power supply in order to avoid possible accidents.
All regulations and rules must be taken into consideration when installing the iSmartgate-01W device.
The electrical installation of the iSmartgate-01W should be done by a professional.
ATTENTION
Before to connect the load to the device outputs, check figure 6 for the maximum current
and voltage supported by iSmartGate-01W (http://www.v2fe.com/how-it-works1.html).
ATTENTION
2.2.1 iSmartGate GARAGE Mode Wiring
The iSmartGate-01W has 2 voltage free outputs: RELAY 1 and RELAY2 , to connect with electric or electronic
devices. If you want to control your Garage Door, you need to configure the iSmartgate-01W with the GRG Mode
(Garage mode). If in our iSmartGate APP we have set up the door with GRG MODE , we have to connect the device
as the following scheme:
You can also choose to connect
the iSmartgate-01W to the
Garage Internal Wall Switch,
as in the following scheme:
Figure 3. Connection of the iSmartgate-01W
to a standard Garage Door Control Panel
27 26 25 24 23 22 21 20 19 18 17 16 15 13 12 11 10
9 8 7 6 5 4 3 2 1
M1 M2
N GND F
POWER SUPPL
Y
CCURTESY LIGHT FLASHING LIGHT Max 40w MOT
OR 2 CLOSE
MOT
OR 2 COMMON
MOT
OR 2 OPEN
MOT
OR 1 CLOSE
MOT
OR 1 COMMON
MOT
OR 1 OPEN
CLOSE OPEN P.
P.
PHOT
O1
PHOT
O
ST
OP
SCA COM PHOT
OTEST
24 V 200mA ELECTRIC LOCK 12 V
oc MAX 25 W
LED STATUS
LED OUTPUT 1
LED OUTPUT 2
P.E N L
110/220AC
SEL BACK OK
RELAY 1 RELAY 2
Wi-Fi
Actual Wiring
NEW Wiring
OPEN
button
Inside
CLOSE
button
Inside
Actual Wiring
NEW Wiring
LED STATUS
LED OUTPUT 1
LED OUTPUT 2
P.E N L
110/220AC
SEL BACK OK
RELAY 1 RELAY 2
Wi-Fi
Figure 4a. Connect iSmartGate to your internal garage wall switch.