Iseki SXG19H-UE, Operation Manual

Page: 12 / 96

I. FOR SAFE OPERATION
11
kept in a place always in instant access.
9.14. Avoid high-pressure fluids. Escaping fluid
under pressure can penetrate the skin and cause
serious injury, so keep hands and body away
from pin holes and nozzles ejecting such fluids.
Be sure to consult your dealer about the
hydraulic and fuel injection system troubles.
9.15. If any hydraulic fluid is injected accidentally
into the skin, it must be removed within a few
hours by a doctor familiar with this type of
injury.
9.16. Never allow grass or leaves to accumulate
around heated parts such as the engine and the
muffler, or this may cause a fire.
9.17. Be sure to reinstall the removed parts in place.
Never attempt to start the engine with any parts
removed.
9.18. Never attempt unauthorized modification of the
lawn mower as this could be very hazardous.
Damaged or worn parts should be replaced with
ISEKI genuine spare parts. Unauthorized parts
may cause breakdown of the lawn mower, acci
dents, and ISEKI warranty to expire.
9.19. Keep all nuts, bolts and screws tight to be sure
that the equipment is in safe working condition.
10. ELECTRICAL SYSTEM
10.1. Before servicing the electrical system, be sure
to stop the engine, lower the mower deck on the
ground, draw the starter key, shift the PTO lever
to the OFF position, and apply parking brakes.
10.2. Before inspecting the connections of the elec-
trical system, be sure to disconnect the negative
terminal of the battery to avoid short circuits
and electric shocks.
10.3. Loose connections, terminals, and damaged
wiring should be repaired as soon as possible.
They will not only deteriorate the performance
of electric parts but also may cause short cir-
cuits, leading to fires.
10.4. The surroundings of the wiring and the battery
should be kept clean, or accumulated grass or
chaff may catch fire.
10.5. Never smoke nor allow any open flames nearby
or sparks, which may be caused by short cir-
cuits during servicing the battery. The battery
generates explosive gases(hydrogen and oxy-
gen) during charging, so the battery should
becharged in a place well ventilated to let such
explosive gases diffuse smoothly. Otherwise
settled gases may catch fire.
10.6. Battery electrolyte is diluted sulphuric acid, so
it is corrosive and naturally poisonous. Never
allow acid to contact skin or clothing, or it may
cause burns. Always wear a face shield to avoid
acid getting in eyes. If acid contacts skin or
clothing, wash off immediately with clean
Parts code of blade Punched ID
SCMA 54
Left 8665-306-001-00
I
8665 A
Right 8665-306-002-00
I
8665 B
SCMA 48
Left 8663-306-001-00
I
8663 A
Right 8663-306-002-00
I
8663 B
(1) Negative cord