Iseki SXG19H-UE, Operation Manual

Page: 10 / 96

I. FOR SAFE OPERATION
9
up the mower deck fully and reverse it straight
back at sufficiently low speeds. Drive it for-
ward when unloading it from the truck.
6.4. If the engine stalls unexpectedly on the ramps,
depress the brake pedals immediately and roll
the lawn mower to the ground by releasing the
brakes gradually. Then start the engine and try
again.
6.5. Use ramps with the same or better specifica-
tions mentioned below. When the lawn mower
is equipped with the attachments other than
those included in the specifications mentioned
below, ask your dealers for advice.
Specifications of the ramps
for the SXG 19 and SXG 22
• Length.........more than 4 times the height of the platform
.......................................................................of the truck
• Width(effective width)............................more than 30 cm
• Required quantity................................................2 ramps
• Capacity (one ramp).............................more than 750 kg
• Ramps should have anti-skid surfaces.
• The above specifications are effective with the lawn
mower with the following conflgurations.
• mowers are not equipped with any attachments or a
cabin.
• Lawn mowers are equipped with a standard mower
deck.
6.6. Park the truck on hard level ground. Hook the
ramps securely on the platform of the truck
with the top of the ramp level with the plat-
form.
6.7. Drive the lawn mower carefully at the moment
the lawn mower moves from the ramps onto the
platform, for it changes angles abruptly.
6.8. When the lawn mower is loaded on the truck,
stop the engine, apply parking brakes, and
withdraw the starter key, chock the wheels, and
rope it securely to the truck. Refrain from
unnecessary abrupt starting, stopping, and turn-
ing during transportation, or the lawn mower
may shift position on the truck, which is very
dangerous.
7. WHEN FILLING WITH FUEL:
7.1. Never smoke while ref illing with fuel, nor
allow any open flames near the lawn mower.
7.2. Never open the fuel tank cap while the engine
is running or while it is still hot after operation.
Wait until the engine cools down sufficiently.
7.3. Provide adequate measures to prevent fuel from
spilling when pouring it into the fuel tank. Spilt
fuel should be wiped off completely.
7.4. Avoid refueling indoors. If this is inevitable,
provide sufficient ventilation.
7.5. Replace the fuel tank and container caps
securely.
7.6. Store fuel in containers specifically designed
for this purposes.