Iseki SXG19H-UE, Operation Manual

Page: 49 / 96

SXG
48
native but to replace the f ilter by yourself,
observe the following instructions.
The hydraulic oil filter is located in the Left-hand
side under the step.
(1) Hydraulic oil filter
a. After the transmission oil has drained out com-
pletely, remove the filter using the filter spanner.
When removing the filter, a small amount of oil
may spill, so place waste cloth under the filter to
receive spilt oil.
b. Apply thin coat of oil to the O-ring of the new oil
filter cartridge ahead of time. Then install the fil-
ter. Screw in the filter by hand until the rubber
packing comes into contact with the sealing sur-
face, and then screw in it by a 2/3 turn with the
filter spanner.
Oil: Hydrostatic transmission oil
20. CHAIN CASE OIL REPLACEMENT
Important:
• The chain case oil should be replaced after the
initial 50 hours of operation and then after every
200 hours of operation.
The chain cese oil drain is located lower of left
and right outside chain case.
(1) chain case filler (3) oil level plug
(2) drain plug
a. place a tray under the drain plug.
b. Remove the drain plug and let the oil drain out.
c. Reingtall the drain plug and tighten it securely.
d. Put in the new oil from chain case filler located
upper side of chain case.
Oil: Fear oil SAE80
21. WASHING AND REPLACEMENT OF SUC-
TION FILTER
Important:
• The suction oil filter should be cleaned after the
initial 50 hours of operation and then after every
200 hours of operation. It should also cleaned
every time the transmission oil is replaced.
• It is recommended to ask your dealer to replace
the suction filter. But when there is no alternative
but to replace the filter by yourself, observe the
following instructions.
The suction oil filter is located in the bottom of
the left-hand side of the chassis.
Chain case oil
capacity
1.1 litres (0.24 imp, gal.)