Iseki SBC550X, Operation Manual

Page: 93 / 105

SBC600XH & SBC550XL
92
II. DETACHING AND ATTACHING COLLECTOR
e. Adjust the height of rear position of the container
ASSY (2) by the rear stay adjuster (5), and then lock
the rear stay adjuster (5) by fastening the nut.
(5) Rear stay adjustor
f. Stop the engine. Move the container lift lever (1) for-
ward and backward two or three times to decrease the
residual oil pressure into the lift cylinder ASSY (6).
g. Remove the hair pin (8) from the bottom of the lift cyl-
inder ASSY (6), and then remove the pin (16x61) (7).
h. Move the bottom of the lift cylinder ASSY (6) from the
collector frame (10) to the collector base ASSY (3). Set
it to the collector base ASSY (3) with adjusting the front
adjustor bolt (9), and then lock the collector base ASSY
(3) by fastening the nut of the front adjustor bolt (9).
(6) Lift cylinder ASSY (9) Front Adjustor bolt
(7) Pin (16x61) (10) Collector frame
(8) Hairpin
i. Release four hydraulic pressure hoses from the hose
guide (11).
WARNING: When attaching or detaching the
collector to the lawn mower:
• Place the lawn mower on level, hard ground.
• Apply the parking brake securely. (GE TYPE)
• Apply the parking lock securely. (E TYPE)
• Move the PTO lever to the STOP ( ) position.
• Do not start the engine except for operating
the lift.
1. DETACHING THE HIGH DUMP COLLECTOR
(SBC600X-HQE4)
a. Place the lawn mower on level, hard ground, and then
apply the parking brake (GE TYPE) or the parking
lock (E TYPE).
b. Start the engine. Move the collector lift lever (1) back-
ward, and lift the container ASSY (2) to 20 cm from
the lowest position.
c. Set the collector base ASSY (3) under the container
ASSY (2). Move the collector lift lever (1) forward to put
the container ASSY (2) on the collector base ASSY (3).
(1) Collector lift lever (3) Collector base ASSY
(OPTION) (2) Container ASSY
d. Be sure to put the front bottom of the container ASSY
(2) on the guide (4) of the collector base ASSY (3).
(4) Guide
1 2
3
4
5
6
7
10
9 7 8