II. ATTACHING AND DETACHING MOWER DECK
75
INSTALLATION OF MOWER DECK
a. Start the engine. Move the lift lever (1) backward
(
u
) to raise the mower link in the highest position, and
then stop the engine.
b. Remove the PTO cover (10).
c. Set the gauge wheels (3) of the mower deck in the
lowest position (Refer to page 76).
d. Before installing the mower deck, set the rear gauge
wheels (3) sideways.
e. Depress the lower chute (2) and keep it down with
ring clip (4).
f. Place the mower deck underneath the lawn mower.
g. Insert the discharge cover of mower deck into the
chute of lawn mower.
h. Move the lift lever (1) forward to lower the rear link (5).
i. Install the rear link (5) into the mower deck with pin.
j. Install the drive shaft (6) into the lawn mower.
k. Attach the PTO cover (10).
l. Install the front link (7) into the lawn mower and
mower deck.
WARNING: Put the chains of the drive shaft
(6) on the front link.
m. Replace the lower chute (2) by releasing the hock of
ring clip (4).
n. Start the engine. Move the lift lever (1) backward (
u
)
to raise the mower deck, and then stop the engine.
o. Set the gauge wheels (3) of the mower deck straightly.
p. Return the lower chute (2) by removing the ring clip (4).
IMPORTANT: • When installing and removing the mower
deck, turn clockwise(-) the height adjust-
ment dial (9) fully to lower the mower deck.
• When installing the mower deck, be sure
that the ground clearance of the bottom
surface of the mower deck is as follows;
SXG326 : 150mm, SXG323 : 130mm
• When the mower deck is leaning to for-
ward or backward, adjust length of the
front link (7).
- In case of leaning to forward:
Make length of the front link (7) shorter
- In case of leaning to backward :
Make length of the front link (7) longer
• When SCMB48 is shipped from ISEKI
factory, front link (7) of SCMB48 is ad-
justed for SXG326.
- In case of installing SCMB48 to SXG323:
Adjust the length of front link (7) as the
following size.
2. DETACHING THE MOWER DECK
Detach the mower deck in reverse order of attaching:
Remove the drive shaft first and then the mower deck
from the lawn mower.
CAUTION: Be sure to disconnect the univer-
sal joint on the PTO shaft of the lawn mower.
IMPORTANT: Be sure to keep the removed parts.
Summary of Contents for SBC550X
Page 71: ...SXG 70 ...
Page 72: ...XI ELECTRIC WIRING 71 XI ELECTRIC WIRING E TYPE ...
Page 73: ...72 SXG GE TYPE ...
Page 103: ...SBC600XH SBC550XL 102 ...
