iES26GF
User’s
Manual
UM-iES26GF-1.2.3-EN.docx
Pages 77 of 169
5.6
SNMP
SNMP System Configuration
Configure the Simple Network Management Protocol (SNMP) on this page.
Figure 81 - SNMP System Configuration interface
The following table describes the labels for the
SNMP System Configuration
screen.
Label
Description
Mode
Indicates existing SNMP mode. Possible modes include:
Enabled
: enable SNMP mode
Disabled
: disable SNMP mode
Version
Indicates the supported SNMP version. Possible versions include:
SNMP v1
: supports SNMP version 1.
SNMP v2c
: supports SNMP version 2c.
SNMP v3
: supports SNMP version 3.
Read Community
Indicates the read community string to permit access to SNMP agent. The
allowed string length is 0 to 255, and only ASCII characters from 33 to 126
are allowed.
The field only suits to SNMPv1 and SNMPv2c. SNMPv3 uses USM for
authentication and privacy and the community string will be associated
with SNMPv3 community table.
Write Community
Indicates the write community string to permit access to SNMP agent. The
allowed string length is 0 to 255, and only ASCII characters from 33 to 126
are allowed.
The field only suits to SNMPv1 and SNMPv2c. SNMPv3 uses USM for
authentication and privacy and the community string will be associated
with SNMPv3 community table.
Engine ID
Indicates the SNMPv3 engine ID. The string must contain an even number
between 10 and 64 hexadecimal digits, but all-zeros and all-'F's are not
allowed. Change of the Engine ID will clear all original local users.
SNMP Trap Configuration
Configure SNMP Trap on this page.
Figure 82 - SNMP Trap Configuration interface
