iES26GF
User’s
Manual
UM-iES26GF-1.2.3-EN.docx
Pages 131 of 169
5.10
Warning
The Warning function is very important for managing the switch. The switch can be managed using
SYSLOG, E-MAIL, and Fault Relay. The function helps the user to
monitor the switch’s status at a
remote site. When events occur, a warning message will be sent to the appointed server, E-MAIL, or
relay fault on the switch panel.
Fault Alarm
When any selected fault event happens, the Fault LED on the switch panel will light up and the
electric relay will signal at the same time.
Select the events to cause the Fault Alarm, then click
Save
(at the bottom of the screen) to save the
changes.
Figure 127 - Fault Alarm interface
The following table describes the labels for the
Fault Alarm
screen.
Label
Description
Power Failure
Fault alarm when any selected power failure. This switch support dual
powers.
PWR 1
Add a checkmark if you choose the fault alarm LED to appear on PWR 1.
PWR 2
Add a checkmark if you choose the fault alarm LED to appear on PWR 2.
Port Link
Down/Broken
Fault alarm when any selected port link down/broken.
Port
Indicates a port number.
Active
Add a checkmark to indicate if the port is
Active
.
Save
Click Save to save changes.
