page 5
4.
I
NITIAL POWER-UP, ADDING MASTER KEYS BY RESET BUTTON
Initial power-up sequence (No keys in lock's memory)
-
Connect the reader module to the lock module by a supplied cable.
-
Insert four AA batteries.
-
Swipe
the reader by any EM
-
Marine key.
-
The controller issues audible and visual signals.
-
Device is ready for operation.
Note: For consistent reader operation, keys with label diameter 15…35 mm are recommended.
To add a Master key, perform the following steps:
-
Disconnect the power (take out one of the batteries or use the external power supply switch, per
Fig. 10);
-
Push and hold the RESET button with a sharp tool (hairpin, toothpick, straightened paper clip
etc.)
-
Connect the power (re-insert the battery, or use the external power supply switch again, per Fig.
10), and only after that release the RESET button;
-
Within 5 s after this, push and hold RESET button again;
-
Swipe
up to 4 keys to promote to Master one by one still
holding RESET down;
-
Release RESET button. In 6 s, both audible and visual signals will confirm exit from the Add
Master Key mode.
5. SELECTING AND SETTING OPERATIONAL MODE BY RESET BUTTON
Note:
Cannot select operational mode without a Master key.
The lock supports four
pre-customised
operational modes:
-
Gym mode
: allows not to tie up the key to the lock. The user chooses which of the available
lockers to use.
-
Logic mode
: allows
record
ing the used locker number and battery level into the key
(bracelet). Very convenient when the user
forgets which locker he used.
Allows not to tie up the key
to the lock. The user will decide which of the free lockers to use. Works only with Lock Manager
software.
-
General mode
:
traditional lock controller operation: only the keys
record
ed in lock's database
can open the locker;
-
Safe Deposit Box mode
:
safe deposit box mode emulation. To open the lock, all the keys in
lock's database need to be presented to the lock, one after another.
In addition to the above modes you can order your own
Custom mode
, which will be designed
according to your needs.
At factory
settings
,
Gym mode
is pre-selected by default. It is activated straight after the Master
key(s) have been added. To select a different operational mode, follow these steps:
-
Disconnect the power (take out one of the batteries or use the external power supply switch, as
per Fig. 10);
-
Press and hold the RESET button with a sharp tool.
-
Connect the power (reinsert the battery, or use the external power supply switch, as per Fig. 10),
and only after that release the RESET button;
- Press the RESET button shortly (once). The lock issues audible and visual signals
twice
. The
lock is now in Logic Mode;
- Press
the
RESET
button
shortly (once). The lock issues audible and visual signals
three times
.
The lock is now in General Mode;
- Press the
RESET
button
shortly (once). The lock issues audible and visual signals
four times
.
The lock is now in Safe Deposit Box Mode.
Z-
395
EHT
www.ironlogic.
me
