Assembly guide for EASY ROOF EVOLUTION L-1
In
fo
rm
at
io
n
et
v
is
u
el
s
n
o
n
c
o
n
tr
ac
tu
el
s.
S
o
u
s
rés
er
ve
d
e
m
o
d
if
ic
at
io
n
s
tec
h
n
iq
u
es
s
an
s
p
réavi
s.
This document is the property of IRFTS. It shall not be reproduced or shared with third parties without IRFTS agreement
Model “L-1” 60 Cells 6” Portrait
Installation of the EASY-ROOF system
1°) Place two
mounting
tool (13) on the two
bottom frames as shown on the drawing.
Two sets
of mounting
tools (13) at least will be necessary to mount the system.
2°) a) Place the superior middle bracket (7) and screw with screws 6x40 STAINLESS (9).
b) Place the inferior middle bracket (7) and screw with screws 6x40 STAINLESS (9).
Do Not put the other fixings immediately.
This operation will be carried out later.
DO NOT REMOVE THE MOUNITING TOOL (13) IMMEDIATELY.
NOTE:
also mount the central middle clamp (7) for an assembly
with 6 fixings.
3°) If grounding is not done by connecting the ground
wire directly to PV module, carry out this connection
by connecting a ground wire on the middle brackets
(7).
This way it grounds two PV modules.
Connect
only one mounting bracket by PV module.
Carry out
this connection each second modules for each line of
module.
Center the bracket in the vertical direction in the
positioning
hole (for dilation)
42
12.4.2)
Play min 15 mm
Play min 15 mm
THE USE OF MOUNTING TOOLS IS MANDATORY FOR THE ASSEMBLY OF THE WHOLE SYSTEM.
FOR ASSEMBLY WITH A GLAZING STOP THE USE OF A THIRDMOUNTING TOOL IS
MANDATORYSEE ANNEXE 6 OF THE DOCUMENT PAGE 73 FOR OPRATION “b”.
