3.2 Install and configure the
sensor
3.2.1 Assemble the sensor
1. Using the prepared holes, fasten the plate to
the wall or to the junction box with two screws
(not provided). See "Back plate dimensions"
on page 31.
2. Insert the ferrule in the cable and then the
cable protection ring.
3. Insert the cable protection ring into the ferrule
until it clicks.
4. Insert the cable protector in the cable. If the
cable already has a terminal, see "Procedure
with cable already with terminal" on the next
page.
5. Terminate the cable using an RJ45 connector.
6. Insert the RJ45 connector into the Ethernet
port through the hole on the back of the
sensor until it clicks.
7. If the sensor is already supplied with power,
check that the LED on the sensor is flashing
blue.
8. Insert the cable protector into the hole on the
back of the sensor and press it until it is
entirely housed in the housing.
3. Installation and use
MSK-101-POE | Advanced configuration manual v1.1 DEC 2019 | msk-101-poe_advanced-config_en_wo v1.1 | © 2019 Inxpect SpA
15
