inVENTer 1001-0200, Installation Instructions Manual

Page: 28 / 40

28
INSTALLATION AND ASSEMBLY
28 iV-Light ventilation unit | Installation instructions
4.8 Check function and complete fan installation
► Set unidirectional ventilation operating mode (DL) on the connected controller.
(see the controller's installation and operating instructions)
► Make sure that all reversible fans rotate in the direction appropriate to their connections.
Start direction extract air mode: Start direction supply air mode:
• The clamping screws of the plug connection are directed to the same side.
• The connections of the white and brown cable are swapped.
1 Fan cable [to the fan]
2 Plug-in connector on the fan cable
3 Plug-in connector on the controller cable
4 Fan BUS [to controller]
5 Clamping screws on the controller plug-in
connector
6 Clamping screws on the fan plug-in
connector
Plug-in connector
on the fan cable
Plug-in connector (cable coming from controller)
Start direction extract air
Start direction supply air
Terminal
block
Colour
Terminal
block
Meaning Colour Terminal
block
Meaning Colour
CW (–) Blue III (–) GND (–) White V (–) GND (–) Brown
+ Red IV (+)
Operating
voltage
Green IV (+)
Operating
voltage
Green
CCW (–) Black V (–) GND (–) Brown III (–) GND (–) White
 The functional test has been performed.
► Set heat recovery operating mode (WRG) on the connected controller.
(see the controller's installation and operating instructions)
► Push the connected and checked fan as far as the thermal accumulator.
 inVENTron is connected and installed.
IV (+)
(+)
V (–)
III (–)
III (–)
V (–)
IV (+)
CW (–)
CCW (–)
(+)
CW (–)
CCW (–)
6
3
2
5
1 1
2
3
6
5
4 4