Operation
–
Axle bolt
C
removed from axle tube
D
for clarity.
It is not necessary to remove the axle bolt
C
for
this procedure.
Adjustable Camber System
1.
Open the camber clamp
A
.
WARNING!
–
NEVER position the camber inserts
B
in the
axle tube with more than 3 inches (7.62 cm) (12
indexing marks showing) of the camber insert
B
outside of the axle tube
D
. The camber inserts
B
will not be securely tightened in the axle tube
D
. Possible injury to the user or damage to the
wheelchair may occur.
2.
Position camber insert
B
to the desired position. Make sure
there are no more than 3 inches (7.62 cm) (12 indexing marks
C
showing) of the camber inserts
B
outside of the axle tube
D
.
3.
Slide the indexing ring
E
on the camber insert
B
until it is flush
with the camber clamp
A
.
–
Before using the wheelchair, make sure both
camber inserts
B
are set at the same indexing
mark
C
. This will make sure the distance between
the rear wheel and the wheelchair is the same
on both sides.
4.
Open the camber clamp
A
.
5.
Repeat STEPS 1–4 for opposite side of the wheelchair.
4.16 Adjusting the Axle Tube
WARNING!
–
QUICK RELEASE LEVERS - Make sure the quick
release levers are in the closed position before using
the wheelchair, otherwise injury or damage to the
wheelchair may occur.
–
STANDARD and suspension camber clamps - Make
sure the hex screws are securely tightened before
using the wheelchair, otherwise injury or damage to
the wheelchair may occur.
CAUTION!
–
Adjustable Camber System ONLY - DO NOT close
the quick-release levers or tighten the hex screws
without camber inserts in the axle tube. Damage to
the axle tube will occur.
–
Stand behind the wheelchair to determine left or right.
1171801-A
43
