Top End
®
Terminator™Series
1.
Remove the back height adjustment screws
A
that secure the
back posts
B
to the back uprights
C
.
2.
Slide the back posts
B
out of the back uprights
C
.
3.
Remove the two screws and washers
D
that secure the existing
back upholstery to the back posts
B
.
4.
Slide the existing back upholstery down and off the back posts
B
.
5.
Stand behind the wheelchair and perform the following:
a.
Slide anchor loop section of adjustable tension back
upholstery
E
up onto the left back post
B
with the upper
grommet hole
F
facing the rear of the wheelchair.
b.
Slide adjuster strap section of adjustable tension back
upholstery
G
up onto the right back post
B
with the upper
grommet hole
F
facing the rear of the wheelchair.
6.
Align the mounting hole in each back post
B
with the desired
mounting hole
H
in each back upright
C
.
7.
Install the two back height adjustment screws
A
through the
back upright mounting holes
H
determined in step 6 and the
back post mounting holes
iI
.
8.
Slip adjuster straps
J
through corresponding anchor loops
K
and adjust the back upholstery
L
. Secure with the fastening
straps
M
.
Both back posts should be adjusted to the same height.
WARNING!
–
After the adjustable tension back upholstery
has been positioned to the end-users individual
needs, the fastening straps MUST be securely
fastened BEFORE applying the back upholstery
cover. The adjustable back should be checked
whenever entering the wheelchair to ensure that
the fastening straps are securely fastened.
9.
Secure the back upholstery cover (fastening strap)
M
to the back
of the adjustable back upholstery (fastening strap).
10. Flip the back upholstery cover
L
over the adjustable back
upholstery and secure the fastening straps
M
to the front of
the adjustable back upholstery.
11. Lay the front portion of the back upholstery cover
L
on the
seat pan.
12. Adjust the slack in the back upholstery cover
L
and then secure
to the seat pan fastening straps.
30
1171801-A
