Rea® Dahlia® 30 / 45
3 Settings and Adjustments
3.1 Backrest plate
3.1.1 Height adjustment backrest plate
Risk of damage
Poor functionality on the backrest.
– Any adjustments made to the backrest should
be evaluated by trained personnel.
A
You can easily adjust the backrest plate (+130 mm).
1.
Loosen the four screws
A
.
2.
Set the backrest plate to the required height.
3.
Re-tighten the screws.
Tools: 5 mm Allen Key.
The height of the “Laguna” backrest plate is adjusted
in the same way. Maximum height adjustment is
110 mm.
The “Laguna” backrest cushion is the only available
cushion choice for the “Laguna” backrest plate.
Any adjustments made to the backrest should be
evaluated by trained personnel.
CAUTION!
Risk of pinching
When adjusting the height these is a risk of
pinching your finger.
– Be careful when adjusting the height.
A
B
A
Upper screws for additional height adjustment
B
Lower screws for additional height adjustment
For additional height adjustment (50 mm):
1.
Loosen screws.
2.
Set the required height.
3.
Re-tighten the screws.
Tools: 5 mm Allen Key
3.1.2 Width adjustment backrest plate
WARNING!
Risk of breakage
The backrest might brake if adjusted too wide.
– If you have seat width 490 mm (max seat
width) the backrest should NOT be adjusted to
the widest possibility (+100 mm).
A
B
Tools: 5 mm Allen Key
For width adjustment:
1.
Remove the upper screw
A
, and loosen the lower
screws
B
.
2.
Adjust to the required width (+25 or 50 mm on each
side).
3.
Re-insert the upper screw and tighten.
4.
Tighten the lower screws
The “Laguna” backrest plate is not possible to adjust
in width, only in height.
3.2 Special adaptation of Flex 3 backrest
WARNING!
Safety risk
– All changes to the back are seen as a special
adaptation of the product. That means that the
rules for special adaptation are in force. All
adaptations must be documented and a risk
asessment must be carried out. The adaptor is
responsible for the adaptions.
24
1572308-G
Summary of Contents for REA Dahlia 30
Page 51: ...Notes...
