Rea® Dahlia® 30 / 45
1.
Place the holder
A
on the marked area of the frame.
2.
Attach the mains cable extension to the control box.
See section “Electrical schedule” for more
information about how to connect the cables.
WARNING!
Damage to the battery cable
– Make sure to fasten the cables in a way
that keeps the cables from being squeezed
or stretched.
– Check that the cables run freely when using
the tilt and/or recline function,
A
B
3.
Re-mount the seat plate
B
.
4.
Tighten the screws
A
.
2.22.2 Charging the battery
Damage to the battery
– The battery must be charged 24 hours before
using the system the first time.
– Unplug the mains cable after charging before
using the wheelchair.
The battery charger has different charging cables in
order to adapt to different local electrical standards.
When the battery level is low (20 %), the system
beeps when it is in use.
Connect charger cable
CAUTION!
Damage to the cables.
– Do not sit in the wheelchair while charging the
battery.
D
a hlia 45
A
A
A
B
1.
Connect the charger cable supplied with the chair into a
wall socket.
2.
Insert the charger cable
A
into the connector
B
which
is located on the front of the wheelchair.
3.
Unplug the cable when the battery is fully charged.
Hand control — Battery indications
A
B
C
D
A
Green light — ON — Hand control is activated
B
•
Green light — ON — Battery level is above 20%
•
Green light blinking — ON — Battery is charging
(fixed light when the battery is fully loaded)
C
•
Yellow light — ON — Battery level is low, below
20%
D
Green light — ON — Battery cable is connected
(lights up about 5 seconds after connecting the
cable)
2.22.3 Mounting the actuators
WARNING!
Risk of injury
The wheelchair may collapse
– Check that the locking washers are securely
locked.
– If the safety pin is used, make sure that the
lock shackle / loop is securely locked.
WARNING!
Safety risk
The wheelchair may collapse
– Remember to always reinsert and fasten the
safety pin when it has been removed.
– Check that the lock shackle / loop is securely
locked.
C
WARNING!
Electrical version
The backrest may come loose if the piston rod is
accidentally detached from its housing.
– Before attaching the piston to the backrest,
turn the piston rod
C
maximum clockwise.
– When aligning the holes, only turn the piston
rod
C
maximum a half turn counterclockwise.
16
1572308-G
Summary of Contents for REA Dahlia 30
Page 51: ...Notes...
