Assembly
2.12.1 Mounting of the tilt/recline reduction bushing
The reduction bushings can be used both for the seat
tilt and the backrest recline on Dahlia 30º and for
the backrest recline reduction on Dahlia 45º.
A
A
1.
Mount the reduction bushing
A
on the gas piston rod
by manually pressing it on to the rod.
2.
Remove the reduction bushing
A
by manually twisting
it from the gas piston rod.
0 -
20
°
0 - 10°
0 -
20° 0 - 10°
When using one bushing, the tilt/recline reduction is
10, with two bushings, the tilt/recline reduction is 20.
For information about seat tilt reduction for Dahlia
45, see chapter “Mounting the seat tilt reduction
block”.
2.12.2 Mounting the seat tilt reduction block
A
B
C
C
1.
Place the reduction block
A
in the slider attachment
B
on the seat frame.
2.
Fasten the screw
C
and tighten.
3.
Repeat the procedure with the second block.
Torx driver T20
0
- 20
°
0 - 10°
0 - 30°
With these reduction blocks mounted, the seat tilt
limit is 30. See chapter “Mounting of the tilt/recline
reduction bushing” for information about backrest
recline reduction for Dahlia 45.
2.13 Repositioning the backrest joint
The width extension spacers can be used when there
is need for a wider backrest bar. The spacers will add
an extra 25 mm space on each side.
A
B
C
1.
Loosen the three screws
A
on the outside of the seat
frame.
Tools: 5 mm allen key
2.
Insert the plastic spacers
B
between the backrest
attachment
C
and the seat frame.
3.
Retighten the three screws
A
(10 Nm).
4.
Repeat the procedure on the opposite side.
2.14 Mounting the legrest attachment for high
position
With the high position legrest attachment, the
fixation of the legrest will be 5 cm higher.
The high position legrest attachment is recommended
for users with a height of 185 cm and taller.
1.
A
B
C
Remove the upper screw
A
and the lower screw and
washer
B
. Remove the ordinary legrest attachment
C
.
Tools: Screwdriver (PH 2) for screw
A
, allen key 5
mm for screw
B
.
2.
D
B
A
Mount the high legrest attachment
D
in the seat frame.
Re-insert the upper screw
A
and the lower screw and
washer
B
. Re-tighten the screws.
Tools: Screwdriver (PH 2) for screw
A
, allen key 5
mm for screw
B
.
1572308-G
11
Summary of Contents for REA Dahlia 30
Page 51: ...Notes...
