Assembly
2.20 Mounting the wire for the One arm brake
A
B
C
D
D
1.
Attach the wire
A
to both sides of the brake
B
and
C
.
2.
Fixate the wire with the nut and washer
D
.
2.21 Mounting One arm brake
E
F
G
H
1.
Attach the brake
E
to the attachment nut
G
.
In some configurations, the attachment nut
G
needs to be placed in the attachment
H
prior
to attaching the brake.
2.
Fixate the attachment nut
G
with the screw and washer
F
.
3.
Attach the brake
E
and the attachment nut
G
to the
attachment on the chassis
H
.
4.
Adjust the distance between the brake tap and the rear
wheel.
5.
Adjust the brake effect.
See section “Adjusting the brake” for more
information.
6.
Tighten the screw
F
.
7.
Repeat the procedure on the opposite side.
2.22 Mounting the electrical tilt
WARNING!
Risk of injury
– Make sure that all parts are disconnected from
the power source.
CAUTION!
Risk of short circuit
– Be aware of electrostatic discharge (ESD) when
working on electrical parts.
2.22.1 Mounting the battery
When changing the battery, the hand control cable
needs to be connected for at least 10 seconds to be
able to indicate the levels of the new battery.
A
B
1.
Loosen and remove the screws
A
and the seat plate
B
.
A
1.
Mount the attachment with the battery
A
on the frame.
Mounting the holder for the mains cable extension
A
1572308-G
15
Summary of Contents for REA Dahlia 30
Page 51: ...Notes...
