Invacare LiNX REM400, User Manual, Page: 90 / 101

60126081-C 89
8 Troubleshooting
8.1 Fault Diagnosis
If the electronic system shows a fault, use the following fault-finding guide to locate the fault.
Ensure the drive electronics system is powered up before starting any diagnosis.
If the Status Display is OFF:
l
Check whether the drive electronics system is powered up.
l
Check whether all cables are correctly connected.
l
Ensure the batteries are not discharged.
If a Fault Number Displays in the Status Display:
l
Proceed to the next section.
8.1.1 Fault Codes and Diagnosis Codes
If there is a fault with the system when it is powered up, a fault icon A displays in the status bar. The number inside the triangle
indicates the fault type.
Additionally, the status LED inside the ON/OFF button flashes red. The number of flashes matches the number in the fault icon in
the status bar.
The table below describes the fault indication and a few possible actions that can be taken to rectify the problem. The actions listed
are not in any particular order and are suggestions only. The intention is that one of the suggestions may help clear the problem. If
in doubt, contact your provider.
Fault Icon Fault Description Possible Action
Remote fault
l
Check cables and connectors.
l
Contact your provider.
Network or configuration fault
l
Check cables and connectors.
l
Recharge the batteries.
l
Check the charger.
l
Contact your provider.
Motor 1
1
fault
l
Check cables and connectors.
l
Contact your provider.
Motor 2
1
fault
l
Check cables and connectors.
l
Contact your provider.
8 Troubleshooting