SECTION 15—SEAT
Part No 1125031
83
Tilting the Seat Assembly Forward
1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat
assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the front seat post and secure into clip.
3. Using both hands, slowly tilt the seat assembly forward into the down/closed position.
WARNING
Ensure the two screws are fully engaged and the Formula PTO Plus frame is
securely locked in place before use - otherwise injury or damage may result.
4. Insert the two screws through both the Formula PTO Plus frame and the two front seat
posts/seat brackets.
Removing/Installing the Seat Pan
ASBA Seats
NOTE: For this procedure, refer to FIGURE 15.2 on page 84.
NOTE: The following tools are required to perform this procedure.
• Two 7/16-inch Sockets with Ratchet
• Torque Wrench
Removing
1. Remove the seat cushion by lifting up and disengaging from strips on the seat pan.
2. Remove the two long hex screws and locknuts that secure the seat pan, seat
positioning strap and pull pin to the seat frame.
3. Remove the four short hex screws, spacers, and locknuts that secure the seat pan to the
seat frame.
4. Remove the seat pan.
Installing
1. Secure the rear of the seat pan, seat positioning strap, and pull pin to the seat frame
with two long hex screws and locknuts. Torque to 75 in-lbs ± 20%.
2. Secure the front of the seat pan to the seat frame with four short hex screws, spacers,
and locknuts. Torque to 75 in-lbs ± 20%.
3. Install seat cushion onto seat pan.
