SECTION 13—POWER ELEVATING LEGRESTS
Part No 1125031
57
SECTION 13—POWER ELEVATING
LEGRESTS
WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
Before performing any maintenance, adjustments or service, always turn the wheel-
chair power off, otherwise injury or damage may result.
NOTE: These procedures apply to TDX wheelchairs only.
NOTE: For complete operating information on Invacare elevating legrests, refer to the TDX
Owner's Manual listed in Reference Documents on page 8.
Installing/Removing the Power Elevating Legrests
WARNING
To prevent personal injury, always verify proper positioning of legs and feet prior to
use. Individual user weight may impact the rate of travel for each legrest assembly.
If simultaneous operation is desired, select a speed which allows for the most
uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may
occur.
CAUTION
NEVER allow items to become trapped between the legrest assemblies, otherwise
damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before rais-
ing and lowering. Otherwise damage to the power legrests may occur.
NOTE: For this procedure, refer to FIGURE 13.1 on page 58.
Installing the Power Elevating Legrests
1. Turn power legrest to side (open footplate is perpendicular to wheelchair) and align
the mounting pin on the legrest with mounting hole in the hanger assembly
(Detail “A”).
