SECTION 16—TILT
Part No 1125031
109
FIGURE 16.5
Preparing to Replace the Tilt Actuator / Preparing the Actuator for Use
Removing the Tilt Actuator
NOTE: For this procedure, refer to FIGURE 16.6 on page 111.
1. Remove the two cap screws securing the cam harness cable and cam switch cover to
the tilt assembly (Detail “A”).
2. Move the cam switch cover to the side.
WARNING
When both threaded pivot pins or the clevis pin are removed, the seat assembly will
be unsupported by the tilt assembly. Ensure the seat assembly is supported from
behind until the new actuator has the clevis pin and at least one threaded pivot pin
installed. Otherwise, the seat assembly may fall backward and injury or damage
may occur.
3. Ensure the seat assembly is supported from behind by an assistant or a stationary
object.
4. Remove the threaded pivot pin securing the right side of the actuator to the front of
the tilt frame (Detail “B”).
5. Remove the threaded pivot pin securing the left side of the actuator to the front of the
tilt frame (Detail “B”).
6. Remove the cotter pin and washer from the clevis pin (Detail “C”).
7. Remove the clevis pin securing the rear of the actuator to the tilt frame support
(Detail “C”).
8. Remove the actuator.
Rear of Tilt Frame
Support
Cam Switch
Cover Bracket
Large Tie-wrap
Actuator
NOTE: Spring
assist removed for
clarity.
