SECTION 18—MK5 ELECTRONICS
142
Part No 1125031
Programming the TAC
NOTE: For this procedure, refer to FIGURE 18.8 on page 141.
NOTE: This procedure is for programming a TAC when it has been installed onto a system that
previously had a SAC or TRSS installed.
1. Connect the remote programmer into the front face of the TAC.
2. Press the Power button to turn on the remote programmer.
3. Scroll to the ADVANCED menu and press the Select button.
4. Scroll to SYSTEM TYPE and select the appropriate standard program.
5. Press the Save button.
6. Press the Menu button.
7. Scroll to ACTUATOR SELECTION and press the Select button.
8. Select each direction input control and adjust to the following settings:
• Forward - U/D
• Reverse - U/D
• Right - Up
• Left - Down
9. Press the Save button.
10. Press the Menu button.
11. Scroll to PERFORMANCE ADJUST and press the Select button.
12. Scroll to LIMITS TYPE and press the Select button.
13. Select the appropriate input type (Mercury Switches) and press the Save button.
14. Adjust the Tilt Sensor. Refer to Adjusting/Replacing the Tilt Sensor on page 139.
