SECTION 16—TILT
114
Part No 1125031
7. Install the actuator shroud. Refer to Removing/Installing the Actuator Shroud on
8. Connect the joystick.
9. Turn the joystick on.
10. Use the tilt function to return the seat to the down position.
11. Test the operation of the tilt system to ensure no cables are being pulled, crushed or
damaged. If necessary, remove tie-wraps and reposition new tie-wraps to secure the
cables and prevent damage.
Removing/Installing the Cam Harness Cable
NOTE: For this procedure, refer to FIGURE 16.7 on page 113
Removing the Cam Harness Cable
1. Use the tilt function to tilt the seat back.
2. Remove the actuator shroud. Refer to Removing/Installing the Actuator Shroud on
3. Turn the joystick off.
4. Disconnect the joystick.
5. Remove the rear shroud from the wheelchair. Refer to the owner’s manual listed in
Reference Documents on page 8.
6. For proper installation, note the locations of the tie-wraps securing the cam harness
cable.
7. Cut the tie-wraps securing the cam harness cable to the tilt assembly and/or any other
cables.
8. Unplug the actuator from the cam harness cable (YELLOW connector).
9. Unplug the cam harness cable from the TRSS, SAC, TAC or controller harness (MK6i).
10. Remove the two cap screws securing the cam harness cable to the tilt assembly
(Detail “A”).
11. Slide the cam harness cable to the front end of the cam switch cover (Detail “B”).
12. Remove the pin from the large hole in the end of the cam switch cover.
13. Remove the cam harness cable.
Installing the Cam Harness Cable
1. Insert the pin into the large hole in the end of the cam switch cover (Detail “B”).
2. Slide the pin backward approximately one inch.
