SECTION 13—POWER ELEVATING LEGRESTS
Part No 1125031
59
Adjusting the Power Elevating Legrests
Adjusting the Footplate
WARNING
DO NOT remove heel loops without providing some other adequate means of sup-
port. Otherwise personal injury may occur.
Adjusting the Footplate Height
NOTE: For this procedure, refer to FIGURE 13.2.
NOTE: The following procedure should be performed with the user in the wheelchair.
NOTE: T-nuts ride in the channels of the exterior/interior rails of the power legrests. Refer to
FIGURE 13.2.
1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate
assembly to the T-nuts.
2. Loosen, but DO NOT remove, the two exterior button screws that secure the footplate
assembly to the T-nuts.
3. Loosen, but DO NOT remove, the two button screws that secure the heel loop to the
T-nuts.
4. Slide footplate assembly up or down, until desired height is achieved.
5. While holding footplate assembly in position, tighten all six button screws that were
loosened in STEPS 1-3.
6. Repeat STEPS 1-5 for opposite footplate if necessary.
NOTE: If this procedure does not provide enough length, adjust the length of the power legrest.
Refer to Adjusting the Length for Power Legrest on page 63.
FIGURE 13.2
Adjusting the Footplate Height
Exterior Rail
Channel
T-Nuts (NOT SHOWN)
Footplate
Assembly
Exterior
Button Screws
Outside View
Inside View
Exterior Rail
Channel
T-Nuts (NOT SHOWN)
Footplate Assembly
Interior Button
Screws
Button Screws
for Heel Loop
