E-3
RIMER BULB
gine. To provide fuel to the engine before starting, pump the bulb until some
sistance is felt.
g. These components are accessible from the round deck access
late under the control helm.
ANK FILL
wale adjacent to the Control Helm. The deck plate cap is red
color and marked FUEL.
ded by the Engine Manufacturer. Also, ensure the Deck fill Plate cap is always in place
nd tight.
mmendation do not operate the engine at high RPM’s. Damage to the
ngines can result.
when filling your boat with gasoline to ensure the safety of
your boat an
hts on the boat
5.
ter have a good
7.
r is installed on your boat operate it for 5 minutes before starting
your engines
ANK VENT
to the atmosphere for
lling the tanks and relieving the suction caused by the engine fuel pump.
spect the Tank Vent fitting periodically to ensure that the internal screen is free of debris.
UEL LEVEL SENDER
visible
tank. It is
operated by the same float mechanism as the electrical portion of the sender.
P
The Primer bulb is used to prime the fuel lines between the Shutoff Valve and the engine with fuel
before starting an en
re
Located on the forward end of the tank surface are the tank fill and vent fittings, fuel tank level
sender and a tank bonding lu
p
T
The tank fill fitting is connected to the large fuel fill hose from the Fuel Tank Fill Deck plate. The
deck plate is located on the Port gun
in
NOTE
To maintain the integrity of the Fuel System, do not fill the tanks with anything but the gasoline
recommen
a
NOTE
If it is necessary to fill the fuel tank with gasoline with a octane rating lower than the Engine
Manufacturer’s reco
e
NOTE
The following procedure is to be used
d the people aboard it.
1. Close all hatches, doors and port lig
2. Do not smoke or light any matches
3. Do not operate the engines or any electrical equipment
4. Ensure the metal of the fill nozzle is in contact with the metal of the deck plate
To minimize the amount of spillage from the tank vent into the wa
idea of the amount of gasoline you will be pumping aboard the boat
6. After the fueling is complete, visually check all fuel fittings for leaks
If an optional blowe
T
The Fuel Tank Vent fitting is located on the Port hull side adjacent to the Control Helm and below
the Fuel Tank Fill Deck Plate. It provides the ability for the tanks to vent
fi
NOTE
In
F
Installed in your fuel tank is a Fuel Level Sender. This float operated electrical device provides
the circuit required for operating the Fuel Gauge on the Control Helm. The fuel sender and gauge
provide an indication of the remaining fuel in the tank as a percentage of capacity. On the
portion of the fuel sender is a mechanical indicator of the level of the fuel in the
