NOTE
If connecting an owner supplied accessory to this circuit ensure that the accessory
manufacturer’s recommended fuse size does not exceed 15-amps. Failure to do so may cause
damage to your boat or it’s electrical system.
ELECTRIC HELM SEAT (OPTION)
The Accessory # 6 circuit is used to power and protect Electric Helm Seat option.
This option uses a screw actuator to move the Helm Seat in the forward or aft direction. The
actuator is located under the Helm Seat base. A switch on the side of the helm seat controls the
actuator. Depressing the forward side of the switch will cause the helm seat to move forward,
depressing the aft side of the switch will cause the helm seat to move aft.
ELECTRIC HELM SEAT
CONTROL SWITCH
17. ACCESSORY # 7
The Accessory # 7 circuit provides a means to add additional equipment to your Intrepid.
The Accessory # 7 circuit is powered by the Starboard Battery System and a 15-amp circuit
breaker protects its circuitry.
NOTE
If connecting an owner supplied accessory to this circuit ensure that the accessory
manufacturer’s recommended fuse size does not exceed 15-amps. Failure to do so may cause
damage to your boat or it’s electrical system.
1. CABIN
BILGE
PUMP
Refer to the section on Bilge Pumps on page D13 of this manual for instructions on operating this
Bilge Pump.
2. SUMP
PUMP
The Cabin Sump Pump circuit provides the ability to pump out accumulated water from Shower
and Air Conditioner Condensate Pan (when installed).
D-20
