ITABAR-Sensor Type
IBFD
Operating
Manual
The installation of the types IBFD-65 correspond to
the type IBFD-20. The only different is, that the
mounting stud is designed with a weldolet.
1. Drill a hole of 60 mm diameter into the pipe.
2. Tack the mounting flange onto the pipe leaving a
clearance of 4 mm. The bolt holes of the flange
must be at 22,5° angles to the pipe axis (see Fig.
13). Check the alignment of the mounting
flange.
Fig. 13
3. Observe the H-dimension during the welding of
the mounting flange (see also Fig. 14).
Fig. 14
4. Check the alignment of the mounting flange
again - this is important for the exact position of
the condensation vessels.
5. Now the ITABAR sensor can be installed into
the pipe. Place the included gasket on the gasket
surface of the flange. Insert the sensor into the
welded stud and make sure that the arrow on the
sensor flange points in the flow direction.
Tighten the bolts and nuts.
6. Now check the alignment of the condensation
vessel. The condensation vessel have to be
perfectly mounted along a horizontal line.
Check the alignment!
For correction of alignment slightly release stud
bolts on the mounting flange. For correct align-
ment tighten stud bolts with required torque
according table 1.
5.7.
Installation of Type IBFD-66
The design of the ITABAR sensor IBFD-66 is
22,5°
10
