IntesisBox
®
PA-AC-ENO-1i / 1iC
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
12 / 43
3.3.3 Distance between receiver and sources of interference
The distance between EnOcean receivers, as it is the IntesisBox
®
and other transmitters
(e.g. GSM / DECT / wireless LAN) or high frequency sources of interference (computers,
audio and video equipment) should be higher than 50 centimeters.
However, EnOcean transmitters can be installed next to any other high-frequency
transmitters without any problem.
3.3.4 Use of repeaters
In case of a poor radio reception, it may be helpful to use a repeater. EnOcean repeaters do
not require any configuration, only a line-power supply is needed. A poor radio signal is
received, refreshed and transmitted again, so nearly a double radio range can be achieved.
Special EnOcean repeaters which can be switched to 2-level function allow two repeaters to
be cascaded.
In order to configure the IntesisBox
®
as a repeater see section 5.3.6.
3.4 Power up
Once the IntesisBox
®
is properly connected and placed, AC unit’s main power can be
connected again.
Then it will start an initialization process, L1 will be ON during 3 seconds and L2 will be ON
during 5 seconds (see the location of the LEDs in Figure 4.1). The normal operation starts
when both LEDs are turned OFF again.
It is important to bear in mind that changes made during the initialization process will not
have effect until it finishes.
