IntesisBox
®
PA-AC-ENO-1i / 1iC
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
29 / 43
8. How to?
8.1 Check if my AC unit can be controlled with the IntesisBox
®
See section 11.
8.2 Disable AC remote controller
There are a two ways to perform this functionality:
a)
Set the “IR disablement” parameter to true using the Intesis Configuration Software
(see section 5.3.6).
b)
Sending a telegram using the EEP [07-20-11], in receive mode, setting the bit DB0.2
to 1 (see section 12). It is important to bear in mind that the transmitter device
needs first to be learnt by the IntesisBox
®
.
8.3 Link sensors to the IntesisBox
®
It can be done either manually (section 4.3.1) or remotely (section 5.1).
It is important to know that just one signal of the EEP of the sensor is going to be linked.
See an example of how an Intesis thermostat (IS-TK04PST) will behave depending on the
way it is linked:
-
If an IS-TK04PST is linked to the Rx profile 0 (On/Off), it will only be possible to turn
on or off the AC unit connected to the IntesisBox
®
using the IS-TK04PST’s switch. It
will not be possible to change the fan speed, setpoint or ambient temperature.
-
If the IS-TK04PST is linked now to Rx profile 2 (fan speed), the fan speed will be
changed by the IS-TK04PST’s fan speed switch. At this point the IS-TK04PST is
linked to both signals, so it will change the fan speed and it will turn on or off the AC
unit.
-
The IS-TK04PST will be fully functional if it is linked to the corresponding profiles:
o
On/Off -> Rx profile 0
o
Fan speed -> Rx profile 2
o
Set point -> Rx profile 4
o
Ambient temperature -> Rx profile 5
8.4 Control & monitor the IntesisBox
®
from a gateway
In order to control the IntesisBox
®
from a gateway it will be necessary to learn this gateway
first. To monitor the IntesisBox
®
from a gateway, the Teach-in procedure will have to be
executed.
a)
Learn the gateway in profile E or F. See section 4.3.2.
b)
Teach profile F to the gateway. See section 4.2.2.
