Intesis
Box
®
KNX
– IR Universal AC
User's manual r1.0 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
13 / 48
Once you are sure your installation is compliant with the specifications, please check the presence sensor or
window contact you would like to use. Basically, sensors only need to be equipped with a potential free external
contact. No matter if the contact is NO (Normally Open) or NC (Normally closed) as you will be able to configure
the contact type (NO or NC) of your sensor in the settings of the Binary Input function (Go to Settings menu in
the IntesisBox WEB Site).
IMPORTANT NOTE:
Please, note that IS-IR-KNX-1i interface will only react if the contact of your sensor is
opened or closed. In the case of the presence sensor, the installer needs to decide the specific settings of the
presence sensor to be applied. IntesisBox will be not responsible of the incorrect settings or incorrect
installations.
Recommendation:
In some presence sensors or window contacts it is possible to setup a delay time to the
external contact. As you will see in this manual, IntesisBox Settings allow the user to setup a timer before
starting with the configured actions. Anyway, we recommend to setup a certain delay time in your presence
sensor or window contact to prevent continuous contact changes in a very short period of time.
