Intesis
Box
®
KNX
– IR Universal AC
User's manual r1.0 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
20 / 48
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Status_ Mode
objects for Auto, Heat, Cool, Fan and Dry will appear. When enabled, a
mode will return a
“1”
through its bit-type object.
5.3.3 Enable use of + / - object for Mode
This parameter shows/hides the
Control_ Mode +/-
communication object which lets change the indoor unit
mode by using two different datapoint types.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Control_ Mode +/-
object and a new parameter will appear.
➢
DPT type for +/- Mode Object
This parameter lets choose between the datapoints
0-Up / 1-Down [DPT_1.008]
and
0-Decrease / 1-
Increase [DPT_1.007]
for the
Control_ Mode +/-
object.
The sequence followed when using this object is shown below:
5.3.4 Enable use of Text object for Mode
This parameter shows/hides the
Status_ Mode Text
communication object.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Status_ Mode Text
object will appear.
▪
Up / Increase
▪
Down / Decrease
DRY
AUTO
HEAT
COOL
FAN
