Interroll Roller Conveyor SH 1110
Maintenance and repair
Version 1.0 (06/2022) en
Translation of original operating instructions
45
4
Place a new roller in the open elongated hole. Pull the drive belt onto the roller in the
process and observe the centering of the roller: Screw roller in the side frame with taper
screws on the right and left.
4
Reinsert the finger guard and fasten it with screws.
Replacing the conveyor bracing
1
1
2
1
Torx screw
2
Conveyor bracing
WARNING
Risk of injury from crushing and electrocution
Installation and maintenance tasks on a conveyor system while it is in operation can cause
crushing and electric shock.
4
Power down the entire conveyor module and ensure that it cannot be started accidentally.
Fasten screws with a tightening torque of 19 Nm.
Requirement:
R
The module is shut down.
4
Unscrew screws (1) on the right and left from the C-profile.
4
Remove the bracing (2) to the bottom.
4
Properly dispose of the old bracing.
4
Position new bracing (2) between the side frames and fasten in the C-profile on the right and
left with screws (1).
