Interroll Roller Conveyor SH 1110
Installation
Version 1.0 (06/2022) en
Translation of original operating instructions
29
Straight roller conveyor -
straight roller conveyor
3
4
2
1
3
2
1
5
1
7
5
1
6
1
Nut
5
Washer
2
Washer (small)
6
Module connector RC
3
Torx screw
7
Roller conveyor
4
Roller conveyor
This connection does not allow incline or decline.
4
If available, disassemble end plate at both modules (4, 7),
see "Removing/installing the end
4
Position the modules to be connected (4, 7) in such a way that the side profiles are aligned.
4
Align the top edges of the module by using the height-adjustable feet of the supports.
4
Check horizontal alignment with a spirit level or rotation laser.
4
Secure the adjusted height.
4
Connect the side profiles of the modules form-fit with each other on both sides by using a
module connector (6).
4
Fasten the module connector with screws (3), nuts (1) and washers (2, 5) in the hole pattern
of the side profiles on the right and left. Use six screws for each profile connector.
4
Fasten the module torsion-free, e.g., by anchoring it to the floor or to adjacent components.
