16
TruVision IP Thermal Camera Configuration Manual
Menu tabs
Description
9.
UPnP
The UPnP (Universal Plug and Play) protocol allows devices to connect
seamlessly and to simplify the implementation of networks in the home and
corporate environments. With the function enabled, you do not need to configure
the port mapping for each port, and the camera is connected to the Wide Area
Network (WAN) via the router.
Enable and set the friendly name detected.
See page 18 for setup information.
10. Email
Enter the email address to which messages are sent when an alarm occurs. See
page 18 for setup information.
11. NAT
A NAT (Network Address Translation) is used for network connection. Select the
port mapping mode: auto or manual. See page 20 for setup information.
12. HTTPS
Specifies authentication of the web site and its associated web server, which
protects against Man-in-the-middle attacks.
To define the TCP/IP parameters:
1. From the Configuration panel, click
Configuration
>
Network
>
TCP/IP
.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6 settings,
MTU settings, and Multicast Address.
3. If the DHCP server is available, select
DHCP
.
4. If the DNS server settings are required for some applications (e.g., sending email),
you should configure the
Preferred DNS Server or Alternate DNS Server
.
5. To be able to automatically detect the network camera by client software, select
Enable Multicast Discovery
. This step is optional.
6. Click
Save
to save changes.
To define the port parameters:
1. From the Configuration panel, click
Configuration
>
Network
>
Port
.
2. Set the HTTP port, RTSP port, HTTPS port and server port of the camera.
HTTP Port
: The default port number is 80, and it can be changed to any port No.
which is not occupied.
RTSP Port
: The default port number is 554. It can be changed to any port number
in the range from 1 to 65535.
HTTPS Port
: The default port number is 443. It can be changed to any port number
that is not occupied.
Server Port
: The default server port number is 8000. It can be changed to any port
number in the range from 2000 to 65535.
3. Enter the IP address and port if you want to upload the alarm information to the
remote alarm host. Also select the
Notify Alarm Recipient
option in the normal
Linkage of each event page.
4. Click
Save
to save changes.
