Chapter 5: Advanced setup
TruVision PTZ 36X Camera User Manual
53
Function Description
SEQUENCE LINE
Select a pre-programmed sequence number that the camera
should execute when an alarm contact is triggered.
AUTOPAN LINE
Select a pre-programmed autopan number that the camera
should execute when an alarm contact is triggered.
CRUISE LINE
Select a pre-programmed cruise number that the camera
should execute when an alarm contact is triggered.
DWELL TIME
Set the duration during which the camera will keep the relay
energized when an alarm is triggered. This relay timer starts
counting from the second the alarm is triggered.
Time options are 1 to 127 seconds, OFF, or Always (on) when
alarm occurs.
ALARM PRIORITY
Set alarm priority from 1 to 4 for each alarm pin.
Note:
If two or more alarm contacts are triggered at the same
time, the lower alarm contact number will have priority. For
example, if Alarm 1 and Alarm 3 are triggered simultaneously,
only Alarm 1 will be handled.
ALARM OUTPUT
Set the alarm output device(s) to be triggered by the alarm: 1,
2, both, off.
EXIT
Select Yes to save any changes and return to Main Page 3.
Alarm detection
You can program the system to respond to motion detection.
Figure 25: Alarm detect menu
Table 24: Alarm detect menu description
Function Description
DETECT SWITCH
Enable or disable the alarm detect function.
DETECT MODE
Select the alarm detection mode:
-
INT FOCUS: Trigger an alarm if the internal focus
changes.
ALARM DETECT
DETECT SWITCH
OFF
DETECT MODE
NONE
BLOCK MODE
NONE
FRAME SET
NONE
FRAME DISABLE
NONE
THRESHOLD NONE
EXITD YES
Summary of Contents for TruVision PTZ 36X
