Intergraph TD-x10 Setup, System Reference Manual

Page: 41 / 98

31
Screws
4. The option board fans are installed as a single, self-contained assembly. Install the new fan
assembly into the chassis and connect the power cables to the system board.
5. Replace the peripheral brace.
6. Close the base unit.
CMOS/Clock Battery
WARNING There is a danger of explosion if the battery is incorrectly replaced. Replace the battery with the
same or equivalent type only, as recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
To replace the CMOS/clock battery:
1. Remove the ISA option boards. The battery is located next to the riser card. Refer to the
following figure.
2. Note the orientation of the battery.