Intergraph TD-x10 Setup, System Reference Manual

Page: 82 / 98

72
Notes:
1. The 300 W power supply meets or exceeds the specifications in the above table. For the noted
specifications, the Maximum values describe the smallest acceptable maximum load, and the
Minimum values describe the largest acceptable minimum load.
2. These outputs are measured at the connector of a loaded cable.
3. The +3.3 V and +5.0 V outputs do not draw more than 240 watts combined.
4. Any combination of +3.3 V, +5.0 V, and +12 V do not exceed their maximum or 300 watts of total
power.
5. The +12 V output is able to supply a peak current of 7 amps for 30 seconds.
6. The sum of Initial Setting Tolerance and Line/Load Regulation does not exceed 3% for the +3.3 V
output, 3% for the +5.0 V output, 5% for the +12.0 V output, and 10% for the negative output
voltages.
7. Current always flows from the +12 V (or -12 V) output to the fans.
8. No output exceeds 240 VA under any condition.
200 W DC Output Specifications
Outputs
#1 #2 #3 #4 #5 Unit
Nominal Output Voltages
1,5
+3.3 +5.0 +12.0
−
12.0
−
5.0
VDC
Continuous Load (Maximum)
1
19
3,4
34
3,4
5
4,5
0.5 0.5 ADC
Continuous Load (Minimum)
1
0 2 1 0 0 ADC
Noise and Ripple (PARD)
(DC to 30 MHz)
2
50 50 100 250 100 mV
pp
Max
Initial Setting Tolerance
6 ±
3%
±
5%
±
5%
±
10%
±
10%
Max
Regulation Line/Load
2,6 ±
3%
±
5%
±
5%
±
10%
±
10%
Max
Overshoot (Turn on/off)
5% 5% 10% 10% 10% Max
Notes:
1. The 200 W power supply power supply should meet or exceed these specifications. For the noted
specifications, the Maximum values describe the smallest acceptable maximum load and the
Minimum values describe the largest acceptable minimum load.
2. These outputs are measured at the connector of a loaded cable
3. The +3.3 V and +5.0 V outputs will never draw over 170 watts together.
4. Any combination of +3.3 V, +5.0 V, and +12 V cannot exceed their maximum or 200 watts of total
power.
5. The +12 V output must be able to supply a peak current of 6 amps for 30 seconds.
6. The sum of Initial Setting Tolerance and Line/Load Regulation will not exceed 3% for the +3.3 V
output, 5% for the +5.0 V output, 5% for the +12.0 V output, and 10% for the negative output
voltages.
7. For +5 V output loads less than 4 amps, the +12 V maximum load shall be limited to 3.5 amps.
8. When the + 12 V output is at minimum load, the +5 V load will not exceed 50% of full load.