77
CD-ROM Drive
The following figure shows the back of the CD-ROM drive.
Audio Connector
Terminator
Sockets
Mode Select
Header
Power
Connector
SCSI Connector
Settings for mode select header, which sets SCSI ID, parity, and other drive functionality are printed on
the CD-ROM drive.
Terminator resistors are installed in the terminator sockets only when active termination is required.
By default, these sockets are empty since termination is provided by the SCSI cable.
Disk Drives
The following disk drives are used in non RAID systems. For information about the RAID drives used
in systems with the internal RAID section, refer to the InterRAID documentation.
Part Number
Vendor Number
Capacity
CDSK111
Seagate ST51080N
1 GB
CDSK094
Seagate ST32155N
2 GB
CDSK098
Conner CFP4207S
4 GB
CDSK123
Seagate ST34371N
4 GB
SCSI ID selection is defined in the following table. Each disk drive has a connector which uses
jumpers to set the SCSI ID. Where Seagate uses ID1, ID2, and ID4 to identify how to set the SCSI ID,
Conner uses 0E1, 0E2, and 0E3.
SCSI ID
ID1/0E1
ID2/0E2
ID4/0E3
0
Off
Off
Off
1
On
Off
Off
2
Off
On
Off
3
On
On
Off
4
Off
Off
On
5
On
Off
On
6
Off
On
On
Summary of Contents for TD-x10 Setup
