Intergraph TD-x10 Setup, System Reference Manual

Page: 47 / 98

37
Bank 3
Bank 2
Bank 1
Bank 0
(Socket J51)
Bank 0
Bank 1
Bank 2
Bank 3
(Socket J58)
6. Position the SIMM in the next available socket so that the notch faces the back of the base unit.
7. Insert the SIMM at a 60 degree angle, pressing it firmly into the socket.
8. Push on the top edge of the SIMM until it snaps into the metal clips and locks into the vertical
position. The socket tabs must fit inside the mounting holes of the SIMM.
9. Repeat steps 5 through 7 for each SIMM.
10. If you installed 128 MB SIMMs in a deskside system, replace the board guide assembly (without
the slot 6 board guide).
11. Replace the graphics boards and PCI option boards.
12. After you close the base unit, restart the system. The new memory is recognized automatically.
Adding Internal SCSI Devices
Desktop systems are equipped with an Ultra SCSI controller for all SCSI devices. You can install
internal Ultra SCSI devices in the drive bays located on the right front side of the base unit. The device
must be a 1-inch high device to fit in these bays. You can install a replacement hard disk drive in the
system hard disk drive bracket between the riser card and power supply. If the hard disk drive is more
than 1-inch high you will not be able to use ISA slot 1. If you install a non-Ultra SCSI device, data
transfer rates are limited to the specification of the device.