81
iQue
®
Screener PLUS Hardware Manual: Part Number 11811 Rev A, Maintenance: Managing Plate Models
If you want to configure an offset location, click the
Modify
button to enable the controls and then use the X
and Y arrows to move the probe to an offset position.
No XY-Offset: probe samples from center
XY-Offset: probe samples from edge
of well (96 Well v-bottom plate shown). of the well (96 well flat bottom plate shown).
IMPORTANT
: At the end of the wizard, be sure to click
Finish
. None of your mapping and calibration steps
are saved until you complete the wizard and click the Finish button.
