Intel SR1630GP - Server System - 0 MB RAM, Service Manual

Page: 89 / 196

Intel
®
Server System SR1630GP / SR1630HGP Service Guide 67
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 55 .
Save this screw. You will use it later.
6. Pull the add-in card from the socket in the riser assembly. You may need to wriggle
the card from front to back to remove it, but use caution so you do not twist or bend
the card. See letter “B” in Figure 55.
7. Install a filler panel over the opening at the rear of the riser assembly. See letter “C”
in Figure 55.
8. Re-install the screw you removed in step 5. See letter “A” in Figure 55.
Figure 55. Removing a Full Height Add-In Card
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing the PCIe* Riser Assembly” on page 62 .
10. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” on page 35 .
11. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
12. Plug all peripheral devices and the AC power cable into the server.
Riser Assembly
Supports one
PCIe* card.
A
C
B
AF003287