Intel SR1530CL - Server System - 0 MB RAM, User Manual

Page: 87 / 188

Intel
®
Server System SR1530CL / SR1530HCL / SR1530HCLS 65
10. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29 .
11. Plug all peripheral devices and the AC power cable into the server.
Installing or Removing a PCI Add-in Card
Caution: The add-in cards are NOT hot swappable. Before installing or removing an add-in card,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
One PCI-X* and one PCI Express* add-in card can be installed. The PCI-X card must be
installed at the left side of the bracket; the PCI Express card must be installed at the right
side of the bracket.
Installing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
“Removing the Server
System Cover” on page 28 .
4. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 61 .
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 68 .
Save this screw. You will reinstall it later.
6. If a filler panel is installed over the opening at the rear of the riser assembly lift it
from the riser assembly. See letter “B” in the figure. Save the filler panel in case
you later need to remove the add-in card.
7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into
place firmly until it seats in the riser card connector, but use caution so you do not
twist or bend the card. See letter “C” in the figure.