Intel SR1530CL - Server System - 0 MB RAM, User Manual

Page: 84 / 188

62 Intel
®
Server System SR1530CL / SR1530HCL / SR1530HCLS
6. If you need to add or remove a PCI riser card, see “Installing or Replacing a PCI
Riser Card” on page 63 .
7. If you need to add or remove a PCI add-in card, see “Installing or Removing a PCI
Add-in Card” on page 65 .
8. If you removed the PCI riser assembly for another procedure, continue with that
procedure.
Installing the PCI Riser Assembly
Note: For clarity, the figure in this series of instructions does not show an attached add-in card.
If you are installing an add-in card, do so before installing the PCI riser assembly into
your server system.
1. Lower the PCI riser assembly into place over the add-in card slot. See letter “A” in
the following figure.
2. Align the three hooks in the PCI riser assembly with the matching slots at the back
of the server system. See letters “B” and “C” in the figure.
Figure 65. Installing PCI Riser Assembly into the Server System
3. Press down uniformly until the two hooks on the rear of the PCI riser assembly
engage the server system back panel slots. The riser cards will seat into the
matching sockets on the server board.
4. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
5. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29 .
A
B
C
AF0009 8 5