Intel SR1520ML - Server System - 0 MB RAM, User Manual

Page: 53 / 160

Intel
®
Server System SR1520ML User’s Guide 33
9. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” on page 29 .
10. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
Replacing the Processor
Note: This manual assumes a processor is already installed and you are referring to these steps
to replace your processor. If you are setting up this system for the first time, see the Quick
Start User’s Guide that was included in the product box.
Caution: Use only processors that have been validated to work with this server board. See “Server
System References” on page xix for a link to the list of compatible processor(s).
Caution: ESD and handling processors: Reduce the risk of electrostatic discharge (ESD) damage to
the processor by doing the following: (1) Touch the metal chassis before touching the
processor or server board. Keep part of your body in contact with the metal chassis to
dissipate the static charge while handling the processor. (2) Avoid moving around
unnecessarily.
Removing the Heat Sink and Processor
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 14 .
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” on page 28 .
5. Loosen the four captive screws on the corners of the heat sink.
6. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
7. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor, which could damage it.
8. Raise the processor socket handle completely. See the following figure.