Intel SDS2, Product Manual

Page: 51 / 100

45
4 Configuration Software and Utilities
This chapter describes the Power-On Self-Test (POST) and server configuration utilities. The table
below briefly describes the utilities.
Table 4. Configuration Utilities
Utility Description and brief procedure Page
BIOS Setup If the system does not have a diskette drive, or the drive is disabled or
misconfigured, use Setup to enable it.
Or, you can move the CMOS jumper on the server board from the
default setting (Protect CMOS memory) to the Clear setting; this will
allow most server configurations to boot. Then run the SSU to
configure the server.
47
System Setup Utility
(SSU) Use for viewing and clearing the system event log, viewing the system
management FRU information, or viewing the system management
SDR repository. 57
FRUSDR Load Utility Use to update the Field Replacement Unit (FRU), Sensor Data Record
(SDR), and SM BIOS (SMB) flash components. 63
BIOS Upgrade Utility Use to upgrade the BIOS. 67
Firmware Update Utility Use to update the Firmware. 70
Using the Adaptec SCSI
Utility Use to configure or view the settings of the SCSI host adapters and
onboard SCSI devices in the server. 72
Hot Keys
Use the keyboard’s numeric pad to enter numbers and symbols.
Table 5. Hot Keys
To do this: Press these keys
Clear memory and reload the operating
system

this is a system reset.
<Ctrl+Alt+Del>
Secure your system immediately. <Ctrl+Alt>+hotkey (Set your hot key combination with Setup.)